Magma PCIe Expansion System EB2R Manuel d'utilisateur télécharger pdf (Page 41)

MAGMA

on the OK button to close the new dialog.

4. The properties dialog should close and the original “Safely

Remove Hardware” dialog should remain.

Click on the Stop button of the dialog.

5. A dialog with the title “Stop a Hardware device” should appear.

This device is used to confirm that the user wishes to stop this

device.

Click on the OK button of the new dialog.

6. After a brief period a pop up will appear telling the user that the

device may be removed safely, and the device will be removed

from the list of the original dialog.

Press the Attention button that corresponds to the slot

where the device is located.

7. An LED, labeled SLOT X Attention (where X corresponds to

the slot number) will begin to flash. The LED is located on the

vertical backplane towards the back edge of the chassis as

shown below:

Note: If, by mistake, you’ve pressed the button corresponding

to the wrong slot, then press it again within 5 seconds and the

hot plug request will be ignored. Otherwise continue to step 8.

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 73 74

Pas de commentaire

Magma PCIe Expansion System EB2R Manuel d'utilisateur Page 41