Magma ROBEN-3PX2 Manuel d'utilisateur télécharger pdf (Page 29)

Magma

Roben 3 | Chapter 2 Hardware Installation

2. Turn power switch to ON position.

3. Thunderbolt expansion unit goes into stand-by mode when the power supply is turned ON. Two green LEDs

on the Interface card are illuminated. No LEDs are illuminated on the backplane.

Thunderbolt Card Installation

Roben-3T (Thunderbolt 3 Slot PCIe expansion) + 8 Drive Bays comes with Thunderbolt Interface card installed. If

you need to install a Thunderbolt Interface card go to Thunderbolt Interface Card Installation on page 22 for

instructions.

Thunderbolt Cable Installation

1. Connect the thunderbolt cable to thunderbolt port on the back of the unit.

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 88 89

Pas de commentaire

Magma ROBEN-3PX2 Manuel d'utilisateur Page 29