Magma ROBEN-3PX2 Manuel d'utilisateur télécharger pdf (Page 28)

Magma

Roben 3 | Chapter 2 Hardware Installation

1. Connect the SAS / SATA Cable to controller card.

a) If you have four drives installed you have to connect one SAS / SATA Cable to controller card.

b) If you have 8 drives, connect two SAS / SATA cable.

NOTE: When installing four drives make sure to place them in one-bay location. The storage bays are divided into

two or four drives per bay.

2. Plug-in controller card in any available PCIe slots and secure it.

3. See Chapter for Hardware and Software Configuration

Plug-in Power Cord

1. Plug in power cord to Roben-3. Make sure the Power Switch on the power supply is turned OFF.

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 88 89

Pas de commentaire

Magma ROBEN-3PX2 Manuel d'utilisateur Page 28