
Media 100 Configurations
17
9600 Media 100 Hardware
■ Vincent™, Vincent 601, P6000
■ HDRfx, E6000, E6001
■ DV600 (attached to P6000)
■ SD600 (attached to E6000/E6001)
9600 Slot Assignment Configurations
We used the following guidelines in constructing Media 100 xr configurations:
■ The P6000 card and the E6000 card must be next to each other since they are connected by an
over-the-top connector cable.
■ The P6000 and E6000 should be placed in slots D2 and E2, because it is in the lower, “cleaner”
PCI bus with less traffic and is further from the heat of the CPU card.
■ The SCSI controller must be in the same PCI bus as the E6000/HDRfx card. Because the
E6000 contains RAM, the system uses that memory instead of going through the PCI bus to the
Mac memory. The system does direct memory transfers within the PCI bus, thus improving
performance. This recommendation is subject to change when other third party PCI cards are
used together in one computer, for example, the Effetto Pronto PCI card.
■ We recommend only one dual-channel SCSI. We do not recommend two dual-channel SCSI
cards in one computer.
We used the following guidelines in constructing Media 100 le-xs configurations:
■ P6000/Vincent in slot E2, because it is in the lower, “cleaner” PCI bus with less traffic and is
further from the heat of the CPU card.
■ The graphics card in the same bus as the P6000 since it does direct access to the graphics card
for the Edit Suite subsampler
■ The SCSI card (or SSA and FC-AL) in a different bus than the P6000 (and E6001 with SD600,
if applicable), since both cards are demanding on PCI bus throughput and can cause bus
contention
■ Gaudi in the same PCI bus as the P6000 (slot D2). However, if you have a 9600/132 or
9600/150, you may have an earlier version of the PCI arbitrator chip and could run into
occasional “Bad Video frame” messages. If you do, place Gaudi in the other PCI bus (slot C1).
Commentaires sur ces manuels